Hej Raju,
Thank you very much for your reply.
I have not yet done anything, but we have a problem, because the technical names of the cubes in DEV and PRD are not the same at the moment.
I know the note you have pointed out, and I have imported it, and set the parameters as described in the note. However, when I run a transport, the technical name is not changed.
Do you know anything about the note, and have you tried to use it? Do we need to clear the cube before the transport to enable the aligning of names?
My idea of deleting the cube is just a result of not succeeding in aligning the technical names using the above note.
Best regards,
Mikkel Kristensen